MDE251M-15 XY Precision Centring Micropositioner (Large Bore Version)

with Micrometers

	Part No. MDE251M-15   Pricing	For use where space is limited No interaction between X and Y axes Two independent dovetail slides Mainly stainless steel Micrometer adjusters Very smooth backlash-free motion Travel +/- 1mm 15mm diameter bore Wide range of configurations

Options and Accessories

Mounting accessories

MDE252 for spigot mounting or to fit into Spindler and Hoyer Microbench

MDE253 or MDE254 for plate or angle plate mounting

MDE254 for M4 post mounting

MDE270 to add tilting movements (see also MDE276)

MDE257 if Z movement required

MDE277 if Z movement and tilting are needed

Note: Surface mating with these micropositioners must be truly flat. Unflat surfaces or overtightened screws will cause the slide motion to be jerky and stiff due to distortion. Dovetail slides, unlike miniature ball slides, are unlikely to be permanently damaged by temporary distortion, as the load is supported on a comparatively large area.