mde250s
 
  [ Home Page ]   [ Contact Us / Events ]
 

MDE250-S  XY Simple Centring Micropositioner
Click to enlarge
Part No. MDE250-S
  Pricing

 

  • For use where space is limited
  • Mainly stainless steel
  • Very smooth backlash-free motion
  • Travel +/- 1mm
  • Standard 11mm diameter bore suits small laser diodes
  • Wide range of configurations

 

 

         

 

      

      

Specifications

Simple centring screw design

Travel in x and y 

±1mm

Sensitivity

<2µm

Bore diameter

11mm

Adjusters

2off  0.25 pitch adjusters

Mounting holes

Two M2 x 3.5mm deep

Thickness

13mm
Options and Accessories
Optional 15mm diameter bore (see MDE250-S-15)
Optional fibre holder model MDE722
Mounting accessories
MDE252 for spigot mounting or to fit into Spindler and Hoyer Microbench
MDE253 or MDE254 for plate or angle plate mounting
MDE254 for M4 post mounting
MDE270 to add tilting movements (see also MDE276)
MDE257 if Z movement required
MDE277 if Z movement and tilting are needed

 

Note: Surface mating with these micropositioners must be truly flat. Unflat surfaces or overtightened screws will cause the slide motion to be jerky and stiff due to distortion. Dovetail slides, unlike miniature ball slides, are unlikely to be permanently damaged by temporary distortion, as the load is supported on a comparatively large area.

 

 
   

Lightspeed Technologies (408)761-0062